|
|
发表于 2006-6-8 03:52:07
|
显示全部楼层
Re:花篮制做方法图文版.
以下是引用 [B]rzq[/B] 在(2004-12-16 12:55:30)的发言：
<img src="attachments/94kk/28591-1-1-38029.jpg" border="0" onload="if(this.width>screen.width*0.7) {this.resized=true; this.width=screen.width*0.7; this.alt='Click here to open new window
CTRL+Mouse wheel to zoom in/out';}" onmouseover="if(this.width>screen.width*0.7) {this.resized=true; this.width=screen.width*0.7; this.style.cursor='hand'; this.alt='Click here to open new window
CTRL+Mouse wheel to zoom in/out';}" onclick="if(!this.resized) {return true;} else {window.open('attachments/94kk/28591-1-1-38029.jpg');}" onmousewheel="return imgzoom(this);" alt="" /><img src="attachments/94kk/28591-1-2-44679.jpg" border="0" onload="if(this.width>screen.width*0.7) {this.resized=true; this.width=screen.width*0.7; this.alt='Click here to open new window
CTRL+Mouse wheel to zoom in/out';}" onmouseover="if(this.width>screen.width*0.7) {this.resized=true; this.width=screen.width*0.7; this.style.cursor='hand'; this.alt='Click here to open new window
CTRL+Mouse wheel to zoom in/out';}" onclick="if(!this.resized) {return true;} else {window.open('attachments/94kk/28591-1-2-44679.jpg');}" onmousewheel="return imgzoom(this);" alt="" />
1:制做一个结实的桩盘,用厚度10mm复合板最好,装修房,小家俱店遍地都是.画圆算出周长后按均分间隔打13个孔,孔径要和选用的螺丝直径一样.桩盘花篮直径为130mm,可以沿内多打几圈孔,以备绕制不同大小的线圈.螺丝6-8mm为益,要长一些,以备脱胎.两头都上螺帽夹紧在桩盘上,绕线的一头根据线径,线圈长度留够长度,过长不好脱胎,过短匝数不够.每个线圈以10-20匝为好,即美观也方便抽头.
[upload=jpg,79.35,450,800,576]285... |
|
[复制链接]
IP卡
狗仔卡
显身卡
